Intended Use - Cleanfix Falcon Safety, Operation & Maintenance Manual

INTENDED USE

•
Only use for wet cleaning of water-
resistant floor coverings in building
interiors.
•
Do not use the auto-scrubber on public
roadways.
•
The autoscrubber is not to be used at
temperatures under 32°F (0°C).
•
The water temperature may not exceed
122°F (50°C).
•
Any other use is considered to be
improper. The manufacturer is not
liable for any resulting damage; all risks
are the responsibility of the user.
•
The appropriate accident prevention
rules, as well
regulations for health and safety in
operation, must be respected.
BEFORE USING THE AUTO-SCRUBBER
QUICKGUIDE
1. Check that the machine is in proper
condition.
2. Remove obstacles, such as furniture
etc. from the area to be cleaned. Large
pieces can be removed to opposite end
of the room from where you start
cleaning.
3. All covers, hoods and lids must be
correctly attached and closed. Make
sure all switches are in the OFF
position.
4. Fill the machine with clean water using a
clean bucket or a hose attached to a
water source.
CHECK IF COMPLETE
•
Machine
•
Squeegee assembly
•
Scrub brushes or pad driver and cylindrical brush
•
Operations manual
Safety, Operation and Maintenance Manual for Falcon (RA 530 B); Version 1.0
as other known
•
Use for intended purpose also includes
adherence to
operating, service and maintenance
regulations.
•
Modifications made to the auto-scrubber
by the user releases Cleanfix from all
liability for resulting damage.
•
Floor coverings must be checked for
suitability for this cleaning method
before using the auto-scrubber!
•
Pay attention to surface pressure in
case of point-elastic floors such as
gymnasium floors.
wheels will not damage the surface.
•
Cleanfix does not accept liability for
damage caused to the machine and
floor covering being cleaned if wrong
brush and chemicals have been used
5. Add the chemical required. Check the
label for the correct dilution portions.
6. Before plugging the batteries in all
switches must be in the OFF position.
All cables and connectors must have
proper protection from spray water.
7. Check all cables for damage and signs
of aging at regular intervals. The auto-
scrubber may only be used if the battery
cables are in perfect condition.
the manufacturer's
Check that the
5