Endless Pools Fastlane Owner's Manual page 3

Section 2 CHOOSING A LOCATION FOR YOUR FASTLANE
The Fastlane can fit in virtually any swimming pool. For optimal water flow, we recommend that you allow
at least 12 feet (3,7m) between the wall on which the Fastlane is installed and the opposing wall in line with
W D
the Swim Unit. The Fastlane has more than 9 square feet (.83m
hazards. The water depth where the Fastlane is installed must be at least 35" (89cm) deep. In addition, the
Fastlane must be installed no closer than 24" (61cm) from any adjacent wall as shown in Figure 2.1, Mini-
mum Clearance Guidelines.
When choosing a location for your Fastlane, you should also consider the route for the hydrualic hoses to
run back to the Power Unit. The Power Unit needs to sit on a solid, level surface, preferably not on wet
ground, and requires a 30-amp, 220-volt GFCI electric service. For UK and international electrical require-
ments, please refer to Section 11. The optional Outdoor Power Unit with Weather Guard may be located
outside, but should not be subject to driving rain. Typically, the Power Unit is located with the other pool
equipment and, if possible, long hydraulic runs should be avoided because of pressure loss. If you wish to
have a run greater than 25' (7,6m), you must transition from 3/8" (9,5mm) hydraulic hoses to 1/2"
(12,7mm) run hoses with the addition of a junction box as reviewed in Section 5.
Fig 2.1
Minimum Clearance Guidelines
Section 3 RECEIVING YOUR FASTLANE
The Endless Pools Fastlane is comprised of a minimum of five (5) parcels. Additional parcels may be
shipped as appropriate. All items will be shipped via UPS Ground.
Items shipped UPS
W D
Parcel 1: Fastlane Swim Unit – propulsion housing
Parcel 2: Fastlane Swim Unit – base with pre-installed,
25 feet (7,7m) of hydraulic hoses, grab bar
Parcel 3: 5-hp Power Unit with 2 Wireless Remote Controls and Antenna located inside the controller
(Heavy Box) Note: If the Outdoor Power Unit was purchased as an option, the Weather Guard
will come pre-assembled to the Power Unit.
Parcel 4: Five (5) Gallons of Hydraulic Fluid (19L) (Non-Food Grade Vegetable Oil)
Parcel 5: Accessories Kit (Wall Mount or Deck Mount)
Wall Mount Accessories Kit
- 2
W - 14
- 16
- 1
- 2
- 1
- 16
- 6
8 JIC Female x 6 JIC Male Adapter
Screw, #10 x 3/4" (19mm), SMS, Blunt Tip, Phil Truss Head,
Type B Point, Type A Thread, Passivated 316SS
Screw, #10 x 1" (25mm), SMS, Blunt Tip, Phil Truss Head,
Type B Point, Type A Thread, Passivated 316SS
Zinc Sacrificial Anode
Protective Hat Channels
Top Lid, Acrylic Pool Propulsion Housing
Screw, 316 SS, M/S, Type 1 Phillips Truss Head, 10-32 x 1" (25mm)
Nut, 316 SS, Lock, Hex, with nylon insert, 10-32
F a s t l a n e S w i m U n i t I n s t a l l a t i o n
®
) of water intake to eliminate any entrapment
2
2