Endless Pools Fastlane Owner's Manual page 13

6.7 Carefully lay the Fastlane onto its front face. Run the hydraulic hoses up the back of the upper hous-
ing. The two hat channels will be placed over the hydraulic hoses. Make sure that the mounting hole in
the end of the hat channel is facing up and that the bottom of the hat channel has been inserted into the
W D
notch in the cylindrical base. Use the provided 3/4" (19mm) stainless steel screws to attach the hat
channels to the upper housing. There will be eight screws per hat channel (Fig 6.5).
6.8 Pull any excess hose out of the hat channel.
6.8a) If the hydraulic hoses are to be run up and over the pool deck, then proceed to step 6.9 (Fig 6.6A).
6.8b) If the hydraulic hoses are to go through the pool wall, attach the two hoses to the top of the upper
housing. There are 2 green hose clamps attached to the top of the housing. The screws that
are securing the clamps to the housing will have to be removed in order to secure the hoses to
the clamps (Fig 6.6B).
Fig. 6.6A
Fig. 6.5
F a s t l a n e
®
Fig. 6.6B
S w i m U n i t I n s t a l l a t i o n
1 2