Description Of Functions For Pumps; Analog Inputs - Grundfos Hydro Multi-E Series Installation And Operating Instructions Manual

Table of Contents

Advertisement

13. Description of functions for pumps

13.1 Analog inputs

Available inputs depend on the functional module fitted in the
pump:
Function (terminal)
Analog input 1, setup (4)
Analog input 2, setup (7)
Analog input 3, setup (14)
* See section
8. Identification of functional
If you want to set an analog input for other purposes, you can do
this manually.
If you make the manual setting via Grundfos GO, you need to
enter the menu for the analog input under the "Settings" menu.
Function
The analog inputs can be set to these functions:
"Not active"
"Feedback sensor"
The sensor is used for the selected control mode.
"Ext. setpoint infl."
See section
13.7 External setpoint
"Other function".
Measured parameter
Select one of the parameters listed below, meaning the
parameter to be measured in the system by the sensor connected
to the actual analog input. See fig. 45.
5
1
DPT
3
13
PT
PT
TT
2
4
DPT
DPT
9
LT
Fig. 45 Overview of sensor locations
Sensor function/measured parameter
"Inlet pressure"
"Diff. press., inlet"
"Discharge press."
"Diff. press.,outlet"
"Diff. press.,pump"
"Press. 1, external"
"Press. 2, external"
"Diff. press., ext."
"Storage tank level"
"Feed tank level"
"Pump flow"
"Flow, external"
"Liquid temp."
"Temperature 1"
"Temperature 2"
"Diff. temp., ext."
"Ambient temp."
"Other parameter"
FM 300*
(advanced)
module.
function.
11
6
14
Q
PT
TT
12
8 16
15
7
Q
DPT DTT
PT
TT
10
LT
Pos.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Not shown
Not shown
Unit
Parameter
Possible units
Pressure
bar, m, kPa, psi, ft
Level
m, ft, in
Pump flow
m³/h, l/s, yd³/h, gpm
Liquid temperature
°C, °F
Other parameter
%
Electrical signal
Select signal type:
"0.5-3.5 V"
"0-5 V"
"0-10 V"
"0-20 mA"
"4-20 mA."
Sensor range, minimum value
Set the minimum value of the connected sensor.
Sensor range, maximum value
Set the maximum value of the connected sensor.
Factory setting
See section
29. Factory
settings.
25

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hydro multi-e 2 crie 5-9 u2 a-a-a-a98486745

Table of Contents