Power On/Off - Midea Eureka i5 Instruction Manual

13mm
15mm
NOTE
1. For the first use, please charge for 12 hours;
2. When the battery is low power, please charge it as soon as possible;
3. If you do not use the appliance for an extended period of time, fully charge the battery and
put it in a ventilated and dry place;
4. If the appliance is not used for more than 3 months, charge the appliance for 12 hours.
Introduction of Remote Control
NOTE
Remote control will work when within 16 feet of the robot.
Docking
Start/Pause
Spot cleaning
Suction decrease
1
Docking: Vacuum will return to docking station to charge.
2
Direction: Manually control the direction of the robot (forward, left, and right). Note that the robot
does not vacuum when in manual mode.
3 Start/Pause: Start or pause cleaning. The robot will automatically begin Smart Path cleaning.
4
Spot cleaning: The robot will clean a specific area in a spiral pattern.
5
Edge cleaning: The robot will clean edges of the room and furniture.
15mm
12
13mm
6
7
Suction increase: Increases the suction power.
8
Suction decrease: Decreases the suction power.
NOTE
a. Before using remote, insert the 2 included AAA batteries. Remove back battery cover and insert
in correct orientation.
b. To prevent the robot from accidentally falling down stairs, there is no backwards direction.

Power ON/OFF

Direction
1
Open the cover and slide power switch
to on.
Edge cleaning
Volume
Suction increase
NOTE
Low Power Test Mode
In this mode, the wifi module will enter the IDLE state, and the cleaner is in a low-power
consumption state and cannot work normally.
Entry: After the cleaner is turned on for 30 seconds, press the left bumper and mute button on the
remote control simultaneously. The operation need to be completed within 1 minute.
Exit: Restart the cleaner.
13mm
15mm
15mm
13
13mm