CONTENTS Safety Instructions Product Maintenance Cleaning the Side Brush Cleaning the Dust Bin, Sponge and Filter Cleaning the Water Tank Product Introduction Cleaning the Sensor and Wheel Cleaning the Charge Terminal Illustration of Appliance Cleaning the Brushroll Introduction of Components Product Operation Trouble Shooting Installing the Side Brushes...
SAFETY INSTRUCTIONS When using an electrical appliance, basis precautions should always be Do not use and store in extremely hot or cold environments( below4°C or above 40°C). Please charge the robot in temperature above 4°C and below 40°C. followed, including the following: Follow all charging instructions and do not charge the battery pack or appliance READ ALL THE INSTRCUTIONS BEFORE USING(THIS APPLIANCE), Failure outside of the temperature range specified in the instructions.
Illustration of Appliance Illustration of Appliance Bumper Spare Filter Start / Pause Dust bin Cover Dust bin release button Water tank Docking station Power switch Dust bin Power socket Water tank assembly Brushroll cover Release button Wheel Water inlet Brushroll Water tank Mop holder Holder...
PRODUCT OPERATION Charging your Robot Vacuum Put the docking station well: Place the docking station against Do not use your robot on wet surfaces or surfaces with standing water. Before using 1.5M/5ft a wall and remove all of obstructions the product on a rug with tasseled edges,please fold the rug edges under. around the docking stand, as shown in the figure below.
Introduction of Remote Control Remote control will work when within 16 feet of the robot. Direction Docking Manually control the direction of the robot (forward, Vacuum will return to docking station to charge. left, and right). Note that the robot does not vacuum when in manual mode.
Power ON/OFF Using APP Open the cover and slide power switch to on. If your home WiFi name or password is changed, you will need to reestablish connection with your robot vacuum. App supports iOS 8.0 and above, Android 4.4 and above phone system versions, but Pad device is not accepted;...
PRODUCT MAINTENANCE Mopping Cleaning the Side Brush Attach the mopping pad to the 2 Press the button on tank and pull holder. to remove. Regularly check the side brush for hair wrapping. Clean the side brush with the cleaning tool or a rag. If the side brush has deformed from hair wrap, remove the side brush by pulling it off of the vacuum and place .
Rinse the dust bin, sponge, and Replace the spare filter holder 3 Lift open the Pour out the remaining water from the water tank. fi l te r w i t h wa r m wa te r. d r y back into the dust bin.
TROUBLE SHOOTING Cleaning the Brushroll With the vacuum turned upside down, place your thumb in the open slot In case of mis-function, please refer to the following table. between the two tabs and lift off to remove brushroll cover. Problem Possible reason Solution The power switch is not...
Page 12
TROUBLE SHOOTING In case of mis-function, please refer to the following table. Troubleshooting Problem Cause Solution The mobile phone shall be accessed to network Judge if the mobile once again; phone is accessed Re-start the router; to network; Power on the cleaner once Judge if the router again;...
Need help?
Do you have a question about the Eureka I5C and is the answer not in the manual?
Questions and answers