SAFETY INSTRUCTIONS CAUTION SAFETY WARNING When using an electrical appliance, basis precautions should always be followed, including the 21. Do not use and store in extremely hot or cold environments( below4°C or above 40°C). Please following: charge the robot in temperature above 4°C and below 40°C. READ ALL THE INSTRCUTIONS BEFORE USING( THIS APPLIANCE), Failure to follow the warnings 22.Follow all charging instructions and do not charge the battery pack or appliance outside of the and instructions may result in electric shock, fire and/ or serious injury.
Product Introduction Illustration of Appliance Introduction of Components Bumper Dust bin Start / Pause Spare Filter Cover Water tank Dust bin release button Docking station Power switch Dust bin Power socket Brushroll cover Water tank assembly Brushroll Release button Mop holder Wheel Water tank Water inlet...
13mm 13mm Installing the Side Brushes Product Operation 15mm 15mm a. Turn the unit over. NOTE b. With unit upside down, align side brush over brush post 1. Do not use your robot on wet surfaces or surfaces with standing water. Before using the product on a rug with tasseled edges,please fold the rug edges under.
13mm 13mm 15mm 15mm NOTE Suction increase: Increases the suction power. 1. For the first use, please charge for 12 hours; 2. When the battery is low power, please charge it as soon as possible; Suction decrease: Decreases the suction power. 3.
Page 8
13mm 13mm 15mm 15mm Clean/Pause Guide for network accessing configuration Clean NOTE Ensure the power switch is in the To begin cleaning, use one of the options below: a. Press the " " key to start cleaning. "ON" position. The product is required to be configured once again network accessing if your home WiFi name or b.
Page 9
13mm 13mm 15mm 15mm Open the upper cover of the cleaner and press power switch; Add Appliance Short press “ ” on the front side of the cleaner and once the voice prompt of successful system start-up is heard, the system is now started successfully; The 1st step: Add by product category Click “+”...
Page 10
13mm 13mm 15mm 15mm Mopping Reinsert the water tank assembly into Attach the mopping pad to the holder. Press the button on tank and pull to Press ‘‘ ’’ to start mopping. the vacuum. remove. NOTE a. It is recommended to fill the water tank 80% full before mopping for the first time. b.
13mm 13mm Product Maintenance 15mm 15mm Cleaning the Side Brush NOTE Wash the filter and sponge ever 2-4 weeks. Rinse the dust bin, sponge, and filter with Replace the spare filter Regularly check the side brush for hair wrapping. warm water. dry THOROUGHLY for 24 hrs. holder back into the dust bin.
13mm 13mm 15mm 15mm Cleaning the Water Tank Wipe dry the water tank and set aside. Exposure to sunlight is not recommended. Once finished mopping, press the water tank release button and pull to remove the water tank. Detach the mop holder and mopping pad by pulling them apart. Cleaning the Sensor and Wheel Wipe the sensor and wheels gently with a soft cloth, as shown in the figure below.
13mm 13mm 15mm 15mm Cleaning the Brushroll Clean the brushroll with a soft cloth or warm water. Dry THOROUGHOLY and reinstall. With the vacuum turned upside down, place your thumb in the open slot between the two tabs Press brushroll lock and lift up to access brushroll. 15mm 15mm 13mm...
13mm 13mm TROUBLE SHOOTING TROUBLE SHOOTING 15mm 15mm In case of mis-function, please refer to the following table. In case of mis-function, please refer to the following table. Problem Possible reason Solution Problem Cause Troubleshooting Solution - The power switch is not turned on - Power on the appliance The appliance will not while charging...
Need help?
Do you have a question about the Eureka i5 and is the answer not in the manual?
Questions and answers