Mounting; Replacing Crackerboard Tine Points; Replacing Tines On The Crackerboard - DAL-BO Frontflex 2000 Series Manual

Mounting

1. Mount new rings, bearings or shaft. Make sure the shaft ends are of equal
2. Assemble in reverse order. Secure the locking bolts and the set screws
Fig. 18
Check the rotational direction of the roller rings. The small and large rings al-
ternate. Closest to the bearing there is a washer followed by a small ring. Re-
member the bushings underneath the large rings (see also introduction to sec-
tion "Repairs").

Replacing Crackerboard tine points

Replace tine points before the tines themselves become worn.

Replacing tines on the Crackerboard

It may be necessary to replace the tines if they become bent or broken.
Fig. 19
Frontflex 2000
length on each side of the rings. (After installing the bearings, measure the
protruding shaft ends to ensure that they have an equal length.).
with (see also introduction to section "Repairs").
1. The Frontflex must be in a lowered position, resting securely on the
ground.
2. Remove the bolts fastening the points to the tines and mount new
points. The bolts may be used again if they are in good condition, but
changing the bolts makes replacing points easier the next time.
1. Remove the bolt in the mounting plate (A), freeing the tine.
2. To mount a new tine, first place the plate onto the square tube, then
position the tine and insert the bolt.
A
· Tine distance 140 mm
side 19