Maintenance; Maintenance Schedule; Tracker™ (Optional); Disinfecting And Cleaning The Restraints - Ferno Mondial MB64 User Manual

7.1 Maintenance Schedule

The cot requires regular maintenance. Set up and follow a maintenance
schedule. The table at right represents minimum intervals for
maintenance. Also see the "Recommended Routine Parts Replacement
Schedule" on this page.
Keep maintenance records. For a sample record sheet, see "Maintenance
Record" on page 35.
When using maintenance products, follow the manufacturers' directions
and read the product material safety data sheets.
7.2 Tracker™ (Optional)
The optional Tracker™ device attaches to the undercarriage and counts
cot cycles. A cycle is recorded each time the cot moves from the folded
position to a raised position and back. The total number of cycles is
displayed on an LCD readout.
Use the Tracker™ as an aid to schedule and record cot maintenance.


Notee: The Tracker™ is designed to maintain a count of the total number of
cot cycles. It is not designed to be reset to zero.
7.3 Disinfecting and Cleaning
the Restraints
To disinfecte:
1. Remove restraints from the cot.
2. Spray or wipe the metal buckles with disinfectant. Allow the
disinfectant to remain on the buckles for the proper contact time.
Wipe with a clean cloth. Do not immerse buckles in liquid.
3. Webbing may be immersed in disinfectant. Follow the disinfectant
manufacturer's instructions for dilution and contact time.
To cleane:
1. Remove restraints from the cot.
2. Add a mild soap or cleaning solution to warm water, using the
recommended dilution.
3. Immerse the restraint webbing in the solution for the proper
contact time. Do not immerse the buckles.
4. Repeatedly dip the restraint webbing in clear water to rinse. Do
not immerse the buckles.
5. Hang the restraints to dry.
6. Attach clean, dry restraints to the cot. For installation directions,
see "Setup" on page 11.
30

Maintenance

7 - MAINTENANCE
Improper maintenance can cause injury. Maintain the cot
only as described in this manual.
Disinfecting (pages 30-31)
Cleaning (pages 30-31)
Waxing (page 31)
Inspecting (page 31)
Lubricating (page 32)
Disinfectants and cleaners containing bleach, phenolics, or
iodines can cause damage. Do not use products containing
these chemicals.
Inspect and replace the transporter parts listed below at the
proper time or cycle count, whichever comes first. To order
kits, see "Parts and Service" on page 33.
* If equipped with control-end leg auto-release.
WARNING
Minimum
Maintenance Each Use
•
Important
Recommended Routine Parts
Replacement Schedule
AS NEEDED
● 100 mm Loading wheel [190-2034]
150 mm Transport wheel [190-2044]
●
Scuff strips [190-2035; 190-2046; 190-2045; 190-2047]
●
EVERY 3 YEARS OR 15,000 CYCLES
Loading-end wheel caster (2) [190-2038]
●
Loading-end swivel-lock pin and spring (2 ea.) [190-2054]
●
Control-end wheel caster w/lock (2) [090-5922]
●
● Control-end wheel-lock lever, spring, and paddle (2)
[190-2036]
EVERY 4 YEARS OR 20,000 CYCLES
Leg control box assembly (each end) [090-5919]
●
Loading-leg lock spring (2) [190-2043]
●
Center control box assembly [090-5920] *
●
© Ferno-Washington, Inc. / 234-3480-06 / November 2017
As Needed Monthly
•
•
• •
•