Ferno Mondial MB64 User Manual page 13

ATTACHING THE SHOULDER STRAPS
Attaching the shoulder straps will be easier if you first buckle the waist
and shoulder straps by placing the shoulder strap links onto the tang
and then insert the tang into the receiver.
1. Lay the shoulder straps flat on the backrest. Verify that the straps
are not twisted.
2. Pass both shoulder straps through the slots in the pad and bed
frame. The guide strap is not used.
3. Pull the loading-end of the restraint keeper outward slightly to
access the keyhole bracket, similar to Figure 3 on page 12. Hold it
in this position while completing Step 4.
4. Working from the inside (closest to the patient surface), insert
the shoulder-strap button into the bracket keyhole closest to the
loading end of the cot. Pull the button firmly upward to seat it in
the narrow portion of the keyhole (Figure 5).
5. Release the restraint keeper.
6. The attached shoulder straps should look similar to those shown
in Figure 6.
Attaching Shoulder Straps
Attach the shoulder straps to the keyhole
bracket nearest the loading end of the cot.
Pressing the rear of the strap/button against
the bracket as you pull upward will help seat
the button in the bracket.
© Ferno-Washington, Inc. / 234-3480-06 / November 2017
Setup
Harness Restraint
Leg Restraint
Loading-end
Bracket Keyhole
5
6
13