Global Configuration Menu - Promax -8 SE Manual

USER'S MANUAL. PROMAX-8

4.2.1 Global configuration menu

In order to access the global
configuration menu, from any operating
mode (SCAN, CH-FR, SPECT, etc.),
you must press the CONFIG [14] key repeatedly
until you see "Global Config: 1 / 2" at the top of the
display (When pressing this key, at first you will
access the configuration menu relative to the mode
in use, which can have more than one page). The
global configuration menu consists of two pages
(attached figure shows the first one), to switch from one to the
C ONFIG [14] key.
In order to modify the state of a given parameter, you must turn the rotary
selector [9] until this one appears shaded and next press it, then the value of the
parameter will appear shaded and turning the selector a new value will be a
d efined. Finally, to validate the new state, press the rotary selector [9] again.
The f irst page of the global configuration menu permits to modify the following
p arameters:
a) CHANNEL PLAN
It allows you to choose the active channel plan between the 10 channel plans that
unit can store (CCIR, EIA, OIRL, FCC, etc.).
b) EDIT CHANNEL PLAN.
When selecting this field
active CHANNEL PLAN
The attached figure shows an example of
channel plan. The first line shows the name of the
channel plan (CCIR in the figure), the audio carrier
offset (5.50 MHz), the modulation type (FM) and the
units of measurement (dBμV). Next line shows the
head of the columns that constitute the channel plan:
the first column (CHAN) shows the name of each
channel (C02, C03,...) and the second one (FREQ)
the associated frequency, in MHz. The third column (BW) defines channel bandwidth, in
MHz. The fourth column (ON) activates or deactivates the channel and the fifth ones
(DIG ) defines if the channel is analogue or digital.
The maximum number of channels in a channel plan is of 140.
The activation (ON) / deactivation (OFF) of the channels affects to the following
operation modes: CH-FR, SCAN and DATALOGGER. When a channel has been
deactivated, this one will not be able to be tuned nor to be measured. This property
allows to make agile the operation of the
activate only those channels in which we are interested.
09/2013
SE
and pressing the rotary selector, the unit accedes to the
.
PROMAX
Figure 5.- Global configuration. 1/2.
other simply press the
ble to be
CCIR 5.50 FM dBuV
CHAN FREQ BW ON DIG
ALL
C02 50.50 7.0
C03 55.25 7.0
C04 62.25 7.0
S01 105.25 7.0
S02 112.25 7.0
Figure 6.- Editing a channel plan.
-8
SE, because it allows to
Page 15