Installing An Independent Deployment Ai/Di Unit - Huawei FusionModule800 Installation Manual

FusionModule800 Smart Small Data Center
Installation Guide
2.
3.
Step 3 Connect the smart ETH gateway ground cable to the ground point on the M-shaped cable
trough, as shown in
----End

3.11.8 Installing an Independent Deployment AI/DI Unit

If an independent deployment AI/DI unit is required, perform the following steps to install it.
Context
You are advised to deploy an independent deployment AI/DI unit at the 42 U position on the
rear top of the IT cabinet adjacent to the Converged Cabinet.
Figure 3-168 Installation position of an independent deployment AI/DI unit
Procedure
Step 1 Remove the PDU2000 cable protective plate.
Figure 3-169 Removing a PDU2000 cable protective plate
Issue 02 (2016-11-15)
Press the lower part of the smart ETH gateway to clamp the smart ETH gateway onto the
guide rail.
Shake the smart ETH gateway in different directions to ensure that it is reliably installed.
Figure 3-167.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Hardware Installation
142