Deployment Wizard - Huawei LUNA2000-200KWH-100KW-2H1 Quick Manual

6. Choose Monitoring > ESM and check
alarm is generated.
9.5

Deployment Wizard

Click Deployment Wizard and set parameters as prompted. Click Skip for unused devices.
•
Set basic parameters.
• After devices are connected, click Search for Device. After the search is complete, click
to check the search result.
•
Connect to a power meter, and set Meter usage to Export+import meter.
•
Connect to EMIs.
•
Set the battery working mode to Maximum self-consumption or TOU.
Parameter Description
It is applicable to the PV+ESS system to increase the self-consumption rate of
Maximum self- PV power. If the PV power is greater than the load power, the excess PV
consumption power is stored in the ESS. If the PV power is less than the load power, the
ESS is discharged.
It is applicable to the PV+ESS system and ESS-only system where peak to
TOU valley electricity prices are different. The ESS can be charged during valley or
shoulder hours and discharged based on loads during peak hours.
a. Set the battery working mode to Maximum self-consumption.
Parameter
Active power threshold of
grid during battery
discharge
Adjustment deadband
Automatic SOC
calibration
in the upper right corner to ensure that no major
Description
Control the maximum target grid power when the grid-connection
point has zero power.
Allowed fluctuation of the target grid power for the grid-connection
point
• Enable: Automatic SOC calibration is enabled. If the total charge
and discharge energy reaches the threshold or the calibration
function has not been triggered for 30 days, the SOC automatic
calibration is performed in battery racks. During calibration, the
cut-off SOC settings will be ineffective and the response of the
charge/discharge power may be impacted temporarily.
•
Disable: Automatic SOC calibration is disabled.
44