Before Installation; Requirements For The Installation Site; Wall; Floor - ABB ACS800 Series Hardware Manual

40

Before installation

The drive must be installed in an upright position with the cooling section facing a
wall. Check the installation site according to the requirements below. Refer to
chapter
WARNING! Do not remove the protective film that covers the unit before the
installation procedure is complete. It protects the unit from pieces of wire cuttings or
other solid particles that can penetrate the unit during installation. Remove the film
just before starting up the unit.

Requirements for the installation site

See chapter

Wall

The wall should be as close to vertical as possible, of non-flammable material and
strong enough to carry the weight of the unit. Check that there is nothing on the wall
to inhibit the installation.

Floor

The floor/material below the installation should be non-flammable.
Mechanical installation
Dimensional drawings
Technical data for the allowed operation conditions of the drive.
for frame details.