Fixed Parameters With The Acs800-11 And Acs800-U11 - ABB ACS800 Series Hardware Manual

Fixed parameters with the ACS800-11 and ACS800-U11

When the IGBT Supply Control Program is loaded into the ACS800-11 or
ACS800-U11, the following parameters are set to the default values given in the
table below.
Parameter
11.01 DC REF SELECT
11.02 Q REF SELECT
98.01 COMMAND SEL
98.02 COMM. MODULE
30.02 EARTH FAULT
70.01 CH0 NODE ADDR
70.19 CH0 HW CONNECTION RING
70.20 CH3 HW CONNECTION RING
71.01 CH0 DRIVEBUS MODE NO
Default value
FIELDBUS
PARAM 24.02
MCW. Note: If par. 16.15 START
MODE is set to LEVEL, the default
value is changed to I/O on the next
RMIO board power-up.
INU COM LIM
FAULT.
Note: The ACS800-11/U11 line
converter is not equipped with
internal earth fault supervision.
120
If changed,
the default values will be
restored on the next power-
up.
the default values will not
be restored on the next
power-up. Do not change.
If the default values are
changed, the drive will not
operate.
Actual signals and parameters
107