Jibsheet Continuous System - Nacra F18 Evolution Assembly Manual

4.6 Jibsheet continuous system

Tools needed:
- Flat screwdriver
1. Use the jibsheet small, one carbo 29mm block
and a shackle D 5mm.
2. Knot one end to the middle of the 29mm block
with a bowline and feed the jibsheet small from
top to botom through the first sheave of the
double block located on the traveller of the
selftacking track.
3. Feed the line back from bottom to top through
the carbo 29mm block and back through the
second sheave of the double block from top to
botom.
4. Feed the line from top to bottom through the
block on the bowsprit located on the starboard
side.
5. Knot the line to the T2 carbo 18mm block.
6. Feed the pre-installed travellerline of the jib
through the cleat mounted on the bowsprit to
range the track.
7. Fixate the jibsheet big line on the starboard side
in the front camcleat and feed it between the
trampoline and the tramp lace underneath the
trampoline, through the bullet sheaves installed
underneath the front crossbar on starboard
side.
8. Feed the line through the T2 carbo 18mm block
which is attached on the jibsheet small.
9. Feed the line on port side between the
trampoline and tramp lace.
10. Feed it through the front camcleat and the ring
already attached to the turnbuckle.
32
11. On port side, un-knot (from the small clamcleat)
the rear pre-installed mouseline in the front
crossbar, and attach it on the jibsheet big.
12. On starboard side, Pull the jibsheet big with the
mouseline through the internal system until it
comes out of the front crossbar.
13. Feed the line through the ring already attached
to the turnbuckle.
14. Attach both ends to each other as shown in
photo A with two bowlines.
15. Adjust the connection to locate it inside the
Front crossbar.
Watch out for the tension on the mouseline!
If the mouseline accidentally slips into
the front crossbar take a close look at the
drawing of the internal system.