Nacra F18 Evolution Assembly Manual page 9

16. Feed the line through the loops from bottom to
top.
17. Loop around the bolt and continue above the
line.
18. Tension the line slightly and tie it temporarily at
the last loop.
19. Now fully tension the trampoline sideways from
front to rear.
20. To secure the line, feed it underneath the
second loop and tie the lacing line with half-hitch
knots.
21. Continue until you reach the end of the line and
install a security knot.
22. Finally tension the trampoline backwards from
port to starboard.
23. After tightening go back two buttons, to secure
the line.
24. Tie the rear lacing line with half-hitch knot.
Continue until you reach the end of the line.
25. Close the trampoline with the two zippers
underneath.
This step is performed after installing
all systems running in between the two
trampoline layers.
26. Use the strapeye on the rear crossbar to tie the
V-strap in the middle.
27. Tie the hiking straps by using the hiking strap
ties.
9