Nacra F18 Evolution Assembly Manual page 25

9. Place the tiller crossbar in between the arms.
• Check if the connector for the tiller extension
is on top.
10. Measure the length between the middle of the
rudder at the back and front of the rudders.
• Measure at the same horizontal level and
start at 10 cm to measure more precisely.
Port Stbd
Port
11. The rudders must face 2 mm inwards, this is
adjustable by changing the rod length.
12. Check if the rod length is the same at both sides
and pre-drill with the 3mm drill before you
screw the philips screw.
13. Fix the sliding bolt for the kick up tension. Push
the bolt forward and fix the bolt while you're still
pushing forward. The sliding bolt needs to be
tightend firmly.
• Use the two 7/16 wrenches.
Stbd
14. If you want to change the rudder rake, change
the rubber for a smaller or bigger rubber.
• Parts are available at www.webshop.
nacrasailing.com
25