Nacra F18 Evolution Assembly Manual page 8

3. Loop the rear lacing line through the tie rod as
shown in the picture. Start at the port side of the
trampoline.
4. Fixate the trampoline with the trampoline plate
on the buttons on the front crossbar. Make sure
you bring the two loose flaps between the beam
and the dolphin striker.
5. The plate needs to be all the way against the
front crossbar. Make sure the buttons stick out
properly.
6. Wrap the trampoline around the front crossbar,
make sure the six cutouts fit the self tacking jib
track bases.
7. Re-install the self tacking jib track.
8
Make sure the trampoline is in the middle
of the catamaran.
8. Loop the laces using the trampoline tie buttons.
9. Tension the line slightly and secure it
temporarily.
10. Tie the side lace line on starboard side to the
most front loop closest to the front crossbar.
11. Feed the line through the loops from top to
bottom.
12. Loop around the bolt and continue underneath
the line.
13. Tension the line slightly.
14. Tie the lacing line temporarily with half-hitch
knot at the last loop.
15. The beginning of the port side is a reflection of
the starboard side.