Jibcunningham - Nacra F18 Evolution Assembly Manual

4.8 Jibcunningham

Tools needed:
- Flat screwdriver
1. Use the two jib cunningham lines and the 18mm
T2 block.
2. Un-knot the shockcord from the clamcleat on
the starboard side, and attach one end of the
jibcunningham line (long) to the shockcord with
two bowlines.
3. Feed the other end of the jibcunningham line
(long) through the small clamcleat.
4. Feed the line through the bullet sheaves located
on the dolphin striker rod underneath the front
crossbar.
5. Feed it through the T2 18mm block, return
through the bullet sheaves.
6. Un-knot the shockcord from the small clamcleat
on the port side.
7. Feed the line through the clamcleat and attach
the shockcord to the line with two bowlines.
8. Knot the jibcunningham line (short) with a
bowline to the T2 18mm block.
9. Feed the line through the cheek block (from
bottom to top).
36