Main Halyard - Nacra F18 Evolution Assembly Manual

5. Install the 40mm carbo pivoting lead block. The
cleat is facing downwards.
6. Feed the spinnaker halyard form inside to
outside through the topblock.
7. Attach the dynema line end of the spinnaker
halyard temporarly to the big bullet.

2.6 Main halyard

1. Knot a figure 8 knot at the bottom of the mast.
2. Feed the main halyard line through the sail
groove towards the main halyard swivel hook.
Feed it through both eyelets of the hook and
guide the line around the mast sheeve.
• Make sure the line goes through both eyelets
of the main halyard swivel hook!
3. Knot the other end of the main halyard line with
a figure 8 knot to the eyelet on the main halyard
ring. Tie everything temporarily to the mast.
21