Chickenline System (Optional) - Nacra F18 Evolution Assembly Manual

1.9 Chickenline system (optional)

Tools needed:
- Flat screwdriver
1. Remove both endcaps from the rear crossbar.
2. Instal the 16mm blocks on both endcaps.
3. Knot one end of the (port) ckickenline to the
shockcord with two bowlines.
4. Knot the other end of the chickenline to the
shackle with a bowline and install the shackle to
the outside hole at the upper gudgeon on port
side.
5. Feed the shockcord (where the port chickenline
is tied to) through the hole in the port endcap.
6. Pull the shockcord to the other side with a long
thin rod. Take a close look at the drawing, the
line/shockcord is crossing the crossbar diagonal.
7. Feed the shockcord through the 16mm block
from top to bottom.
8. Pull the shockcord to the other side and feed it
through the 16mm block from bottom to top .
9. Tie the starboard line with a bowline to the
shackle and install the shackle to the outside
hole at the upper gudgeon on starboard side.
10. Finally pull the shockcord diagonal to the
starboard side (at this point there is a lot of
tension on the shockcord) and knot it to the
starboard line with two bowlines, make sure you
feed the line through the endcap.
14