Spinhalyard; Main Halyard - Nacra F16 Assembly Manual

2.5 spinaker halyard
2. Adjust the block line to the top of the
block and the strapeye above. Fixate the
block on the same height as the bale line!

2.6 Main halyard

1. Mount the mast sheeve with the clevis
pin 1/4 x 3/4 WL
Tape the ring!
1. Take the spin bale line and a carbo 29 mm block. Lead
one end of the spin bale line through the pre drilled holes
in the mast and tie a figure 8 knot. Lead the other end of
the spin bale line through the middle of the block before
mounting it to the mast.
Tape the ends of the bale line to slide easily through the
pre drilled holes!
4. Pull the spinaker halyard throug the topblock
5. Attach the dynema wire end of the spinaker halyard
temporary to the big bullet
NACRA EMPOWERING SAILORS SINS 1975
top
3. Adjust the big bullet pivoting. The cleat is
facing downwards
2. Lead the main halyard line first around the mast
sheeve. Then through both eyes of the main
halyard swifel and guide the line towards the
mastbase, using a small screwdriver
Make sure the line goes through both eyes of
the main halyard swivel!