Weidmuller IE-WL-BL-AP-CL User Manual page 39

Wi-Fi device IE-WL-BL-AP-CL
The IE-WL-BL-AP-CL provides 8 entities for setting IP protocol and source/destination IP addresses in your
filtering policy. Four IP protocols are available: All, ICMP, TCP, and UDP. You must specify either the Source
IP or the Destination IP. By combining IP addresses and netmasks, you can specify a single IP address or a
range of IP addresses to accept or drop. For example, "IP address 192.168.1.1 and netmask 255.255.255.255"
refers to the sole IP address 192.168.1.1. "IP address 192.168.1.1 and netmask 255.255.255.0" refers to the
range of IP addresses from 192.168.1.1 to 192.168.1.255.
Remember to check the Active check box for each entity to activate the setting.
IP protocol filters
Setting
Enable
Disable
Policy
Setting
Accept
Drop
ATTENTION
Be careful when you enable the filter function:
Drop + "no entity on list is activated" = all packets are allowed.
Accept + "no
TCP/UDP Port Filters
The IE-WL-BL-AP-CL's TCP/UDP port filter is a policy-based filter that can allow or filter out TCP/UDP-based
packets with a specified source or destination port.
The IE-WL-BL-AP-CL provides 8 entities for setting the range of source/destination ports of a specific protocol.
In addition to selecting TCP or UDP protocol, you can set either the source port, destination port, or both. The
end port can be left empty if only a single port is specified. Of course, the end port cannot be larger than the
start port.
The Application name is a text string that describes the corresponding entity with up to 31 characters.
Remember to check the Active check box for each entity to activate the setting.
Description
Enables IP protocol filters
Disables IP protocol filters
Description
Only the packets fitting the entities on the list can be allowed
Any packet fitting the entities on the list will be denied
entity on list is activated" = all packets are denied.
3-39
Web Console Configuration
Factory Default
Disable
Factory Default
Drop