Wireless Lan Setup; Operation Mode - Weidmuller IE-WL-BL-AP-CL User Manual

Wi-Fi device IE-WL-BL-AP-CL
Daylight saving time
Setting
Enable/ Disble
When Daylight saving time is enabled, the following parameters will be shown:
• Starts at: The date that daylight saving time begins.
• Stops at: The date that daylight saving time ends.
• Time offset: Indicates how many hours forward the clock should be advanced.
Time server 1/2
Setting
IP/Name of Time
Server 1/2
Time sync interval
Setting
Time interval for NTP
server synchronization
(600 to 9999 seconds)

Wireless LAN Setup

The IE-WL-BL-AP-CL provides the AP/client mode for point-to-multipoint communication.
AP/client: The IP-Bridging mechanism is used to overcome limitations of the 802.11 standards. In this case,
the MAC address of the devices connected to the client radio will be replaced with the client's MAC address.
Under AP/client modes, communication problems might be encountered when you have a MAC authenticated
system or MAC (Layer 2) based communication. In this case, you will need to change the network to use the
master/slave operation mode.
Sniffer: In order to provide an easier way for our customers to analyze wireless traffic, the IE-WL-BL-AP-CL
supports a "Sniffer" mode to co-work with Wireshark packet sniffer software.
NOTE Although it is more convenient to use dynamic bridging, there is a limitation—the Client can only transmit
IP-based packets between its wireless interface (WLAN) and Ethernet interface (LAN); other types of traffic
(such as IPX and AppleTalk) are not forwarded.

Operation Mode

The IE-WL-BL-AP-CL supports three operation modes—AP, Client, and Sniffer—each of which plays a distinct
role on the wireless network.
Description
Daylight saving time (DST or summer time) involves advancing
clocks (usually 1 hour) during the summer time to provide an
extra hour of daylight in the afternoon.
Description
IP or Domain name of the NTP time server. The 2nd NTP server
will be used if the 1st NTP server fails to connect.
Description
This parameter determines how often the time is synchronized
from the NTP server.
3-23
Web Console Configuration
Factory Default
Disable
Factory Default
time.nist.gov
Factory Default
600 (seconds)