Long Parameter Group - ABB EC Titanium Series Manual

10.2 Long Parameter Group

The following tables describes the parameters that are visible in the
sequential listing of all available parameters.
Parameters in the Long parameter mode
No. Name/Value
0000 READ ONLY PARAMETERS
0102 Rotor Speed
(Estimated)
0104 Motor Current
0107 DC BUS VOLTAGE
0109 APPLIED MOTOR VOLTAGE
0110 INTERNAL HEATSINK
TEMPERATURE
0111 SPEED REFERENCE INPUT
0115 KWh/MWh METER
0120 ANALOG INPUT 1 APPLIED
SIGNAL LEVEL
0121 ANALOG INPUT 2 APPLIED
SIGNAL LEVEL
0126 PI CONTROLLER OUTPUT
0140 HOURS RUN METER
0150 INTERNAL DRIVE
TEMPERATURE
0160 DIGITAL INPUT STATUS
0183 DC BUS VOLTAGE RIPPLE
LEVEL
0188 OPERATING TIME
ACCUMULATED WITH
HEATSINK TEMPERATURE
ABOVE 85°C
0189 OPERATING TIME
ACCUMULATED WITH
AMBIENT TEMPERATURE
ABOVE 80°C
10-4 Parameter Definitions
PA-
Description
Pressing the NAVIGATE key when the
enter into the Read only status parameter list shown below. Initially
is shown and using the UP and DOWN Arrows will scroll to the required
Read only status parameter. Pressing NAVIGATE once more on the will then
display the value of that particular Read only status parameter.
For those parameters which have multiple values (e.g. software ID
parameter 3301), pressing the UP and DOWN keys will display the different
values within that parameter.
Pressing NAVIGATE returns to the next level up. If NAVIGATE is then
pressed again (without pressing UP or DOWN), the display changes to the
next level up (main parameter level, i.e. Parameter "
In vector control mode, this parameter displays the estimated rotor speed
of the motor.
8 most recent values prior to trip, updated every 250ms
Displays the instantaneous DC Bus Voltage internally within the drive in V
DC. (0...1000V dc)
Displays the instantaneous output voltage from the drive to the motor V AC.
(0...600V AC)
Temperature of heatsink in °C (-20 ... 100 °C)
Displayed in Hz if Parameter 9908 MOTOR RATED SPEED = 0, otherwise
displayed in RPM. (-2008 ... 2008)
Total number of KWh/MWh consumed by the drive.
Displays the signal level applied to analog input 1 (Terminal 6) in % after
scaling and offsets have been applied.
Displays the signal level applied to analog input 2 (Terminal 4) in % after
scaling and offsets have been applied.
Displays the output level of the PI controller in %.
Not affected by resetting factory default parameters.
(0 to 99 999 hours)
Actual internal ambient temperature in °C
Binary value.
Displays the status of the drive inputs, starting with the left hand side digit
= Digital Input 1 etc.
Displays the level of ripple present on the DC Bus Voltage in V DC. This
parameter is used by the ACS255 for various internal protection and
monitoring functions.
Displays the amount of time in hours and minutes that the ACS255 has
operated for during its lifetime with a heatsink temperature in excess of
85°C. This parameter is used by the ACS255 for various internal protection
and monitoring functions. (HH:MM:SS)
Displays the amount of time in hours and minutes that the DRIVE
has operated for during its lifetime with an ambient temperature in
excess of 80°C. This parameter is used by the DRIVE for various
internal protection and monitoring functions. (HH:MM:SS)
mode (Long Group Parameters) that contain a
0000
parameter is displayed will
00
0000
").
Default
Fault history
(read-only)
MN448