Keypad Operation And Remote Monitoring Displays; Remote Keypad Monitoring Screens - ABB EC Titanium Series Manual

6.3 Keypad Operation and Remote Monitoring Displays

Prior to operation the keypad with show
H x.x
as and while in operation the following displays can be accessed by briefly pressing the Navigate Key.

Remote Keypad Monitoring Screens

Display
Stop
H 0.0.
A 0.0.
P 0.0.
StndbY
MN448
StoP
, pressing the STOP key allows setting the preset speed shown on the display
Description
Drive mains power applied, but no Enable or Run signal applied.
Display shows output frequency (Hz)
Drive running
Display shows motor current (Amps)
Drive Running
Display shows motor power (kW)
Drive Running, Speed Reference = 0
If the enable / disable switch is opened the drive will decelerate to stop at which time the
StoP
display will show . If the potentiometer is turned to zero with the enable /disable
closed the display with show H 0.0 (0.0Hz), if left like this for 60 seconds the drive will go
into standby mode, display shows
Drive running
While the drive is running, the following displays
can be selected by briefly pressing the Navigate
button on the keypad. Each press of the button
will cycle the display through to the next selection.
Stndby
, waiting for a speed reference signal.
Keypad Programming and Basic Operation 6-3