Parameter Definitions; Short Parameter Group - ABB EC Titanium Series Manual

The chapter describes the actual signals and parameters and it also contains a listing of the default parameter values. For a
guide on selecting parameter groups see Chapter 8 Parameter Group Navigation. All parameters are presented in detail and
sequential order in the Long Parameter Group. Parameters are displayed by number, description, default value and range.
No. Name/Value
Parameter
Parameter Name
Number
Input Range

10.1 Short Parameter Group

The following tables describes the parameters that are visible in the
list of settings for general startup of the drive.
Parameters in the Short parameter mode
No. Name/Value
99 Start-Up Data
9902 DIGITAL INPUTS
FUNCTION SELECT
Range 0 to 14
9905 MOTOR (BEMF) VOLTAGE
110V/230V rated drives
0...250V
400V rated drives
0...500V
9906 MOTOR RATED CURRENT
0.25*drive rated output current...
1.0*drive rated output current
9907 MOTOR RATED FREQUENCY
25...500Hz
04 FAULT HISTORY
0401 TRIP HISTORY LOG
MN448
Description
General description of parameter's function
Description of value ranges or reference to other parameters
e Description
Digital Input Configuration and Motor Data Parameter
Defines the function of the digital inputs depending on the value in this
parameter and also on the control mode setting in Parameter 1103
Primary Command Source Mode.
See Chapter 9 Control Modes for 9902 parameter selection details
This parameter should be set to the rated (nameplate) BEMF voltage of
the motor. See Chapter 2 for information on locating motor nameplate
data.
Voltage
Note: The stress on the motor insulation is always dependent on the
drive supply voltage. This also applies to the case where the
motor voltage rating is lower than the rating of the drive and the
supply of the drive.
This parameter should be set to the rated (nameplate) frequency of
the motor. See Chapter 2 for information on locating motor nameplate
data.
Current
This parameter should be set to the rated (nameplate) frequency of
the motor. See Chapter 2 for information on locating motor nameplate
data.
Frequency
Fault history (read only)
When a fault is detected, it is stored in the fault history. Parameters
0401 Trip History Log can be used to display the last four fault codes
for the drive. Press Enter on the Remote Keypad to display the most
recent fault. Use the Up Down arrows to scroll through faults, the most
recent fault is displayed first.
Parameters 0402...0417 show drive operation data at the time of the
latest fault and run time since last trip.
See Chapter 13 Troubleshooting for a complete list of fault codes and
corrective actions.
Chapter 10

Parameter Definitions

PA-S
mode (Short Parameters) and contains a basic
Default
Default value
Default
0
Motor Rating
Dependent
Motor Rating
Dependent
60Hz
Parameter Definitions 10-1