4.
USING THE ANALYSER:
4.1 COMBUSTION TESTS:
Insert the tip of the flue probe into the centre of the flue. The readings will
stabilise within 60 seconds assuming the boiler conditions are stable.
The rotary switch can be used to display the following information:
RATIO Display
NAT GAS
R
0.0008
CO
CO
2
Press
/
Bluetooth fitted).
Hold
/
O2/EFF display
O
2
TF
145.1
TI
Ef C
91.3
Supplied By www.heating spares.co Tel. 0161 620 6677
Defaults to natural gas on start-up. Can be
→
changed via "Menu".
→ CO/CO
52
→ Carbon monoxide (ppm).
6.3
→ Carbon dioxide (%).
to print a full combustion test (also sends to PC if
for 2+ seconds to log a full combustion report.
9.8
Oxygen (%) left after combustion. Should
→
be 20.9% +0.1% in fresh air.
→ Flue temperature (
5.4
Inlet temperature (
→
flue probe during fresh air purge.
Defaults to condensing boiler efficiency
→
(EfC). Can be changed via "Menu".
KANE455 manual
ratio.
2
o
C).
o
C). Normally set by
Page 13