Kane KANE455 Manual page 11

Backlight &
Press
Tasklight
tasklight on and off.
NOTE: Use of the backlight/tasklight significantly
increases the current drain on the batteries.
Switching The analyser normally operates with the pump on.
PUMP on /
Press
off
When the pump is switched off "---PO--" is displayed instead
of the O
"PUMP OFF" on the top line approx every 40 seconds.
NOTES:
1) The pump will not switch off if the CO reading is above
20ppm . This helps to protect the CO sensor from damage.
2) The pump will automatically switch itself off when the
rotary switch is set to Menu, Status, Pressure, Tightness or
Differential Temperature.
Zeroing the
Press and hold
pressure
CAL ZERO.
sensor
Printing Data
Press and quickly release
printing. The analyser displays a series of bars until this is
completed. Press and release the key again to abort printing.
Make sure the printer is switched on, ready to accept data and
its' infrared receiver is in line with the analyser's emitter (on
top of the analyser).
Supplied By www.heating spares.co Tel. 0161 620 6677
/ to switch the display's backlight and
/ to switch the pump off and on.
, CO & Ratio readings. The analyser also displays
2
/
KANE455 manual
until the top line display shows
/ to start the analyser
Page 11