Advertisement
Installing the Cisco 6100 Thermal Upgrade Kit
Attach New Power Rating Label
Complete the following steps to attach the new power rating label:
Locate the power rating label on your current chassis. It is located on the backplane plastic cover.
Step 1
Peel the backing off the new power rating label.
Step 2
Attach the new power rating label directly over the current power rating on your chassis, as shown in
Step 3
Figure 29.
Ensure that the 'C' on the current power rating is not covered by the new label.
Note
Figure 29
Cisco 6100 Thermal Upgrade Kit Installation Procedures
46
If you cannot locate your current power rating label, please attach the new power
rating label to the backplane plastic cover.
Attaching the New Power Rating Label
New label
Old label
78-10158-01
Advertisement
