Cisco 6100 Installation Procedures Manual page 47

Thermal upgrade kit

Close Cisco 6100 Front Door

Verify that the Cisco 6100 front door is attached to the chassis and closed (see Figure 30).

Figure 30

Reconnect the ViewRunner System to the Cisco 6100

If you disconnected the ViewRunner system in the "Disconnect ViewRunner" section on page 13,

complete the steps in the following sections to reconnect the ViewRunner system:

Step 1

Connect one end of the Ethernet cable to the RJ-45 (10BaseT/LAN) connector on the system I/O card.

Step 2

Connect the other end of the Ethernet cable to one of the following:

•

Note

78-10158-01

Cisco 6100 with Front Door Installation

A PC running ViewRunner for Windows software.

A UNIX system running ViewRunner for OpenView software.

Your Ethernet LAN.

If you are connecting the Ethernet cable to a PC, you need a crossover cable.

Installing the Cisco 6100 Thermal Upgrade Kit

C is co 61 00

NI-2

ACO

RESE T

TRNK 1

Cisco 6100 Thermal Upgrade Kit Installation Procedures

EMI gaskets