Table of Contents
Advertisement
Introduction
1.3
Intended use
The TM 225/A was developed for control applications in industrial machines.
The typical applications areas include injection molding machines, robots,
presses, machine tools and similar.
The TM 225/A may only be used for the types of use described in the technical
descriptions and only in conjunction with recommended/approved third-party
equipment/installations.
The TM 225/A has been developed, manufactured, tested and documented in
accordance with the appropriate safety standards. Therefore, the products do
not pose any danger to the health of persons or a risk of damage to other
property or equipment under normal circumstances, provided that the instruc-
tions and safety precautions relating to the intended use are properly observed.
1.4
Notes on this document
This manual is integral part of the product. It is to be retained over the entire
life cycle of the product and should be forwarded to any subsequent owners
or users of the product.
1.5
Documentation for further reading
The following documents are to be observed depending on the system solution
used:
If you are using the KeStudio U2 tool suite:
DE: 65352
EN: 65353
If you are using the KeStudio U3 tool suite:
DE: 1000868
EN: 1000869
8
Doc.No.
K2-200 automation system manual
Doc.No.
System manual Kemro automation
system
Name
● Project engineer
● Electrician
● Programmer
● Commissioning foreman
● Service technician
Name
● Project engineer
● Electrician
● Programmer
● Commissioning foreman
● Service technician
TM 225/A
Target group
Target group
Project engineering manual V1.06
© KEBA 2011
Advertisement
Table of Contents
