Selecting A Project To Execute; Project Execution Mode - Sequence - Equinox Systems ISP juno User Manual

6.6 Selecting a project to execute

Once you have located the 'standalone programming project' which you wish to execute, it is
necessary to press the
below....
Press the key to select displayed project.
e.g. PROJECTNAME1
The programmer will then perform a
'Project Image check'.
This checks that the project data is valid (not corrupt).
Press the key to execute the selected
'Standalone programming project'.

6.7 Project execution mode - sequence

Once you press the to start the
selected 'standalone programming project'.
When the programmer is in 'project execution mode'...
1. The 'BUSY' LED will illuminate.
2. The LCD display will update with the progress of
the project.
ISPJUNO - Portable ISP Programmer - User Guide V0.84 – 17/04/20
key 3 times in order to execute the project as shown in the table
key, then programmer will commence the execution of the
LCD Display message
LCD Display message
Programming...
45