Programmer - Target I/O Signals - Equinox Systems ISP juno User Manual

5.2 Programmer – Target I/O Signals
The ISPjuno programmer features the following programmable signal lines which interface the
programmer and the Target IC(s) to be programmed on the Target System:
•
5 x Programmable Input / Output lines
•
1 x Programmable Output only line
•
1 x Dedicated RESET pin
The diagram below shows the available programmer I/O lines:
Please note:
•
These I/O signals are all available on the 16-way IDC connector but only a selection of the
signals are available on the 10-way IDC connector.
34 ISPJUNO - Portable ISP Programmer - User Guide V0.84 – 17/04/20