Table of Contents
Advertisement
5.0 Target ISP connection – Selection Guide
5.1 Overview of ISP connectors
The ISPjuno programmer features two 'Target ISP Connectors' which are used to interface the
programmer to the target board / device to be programmed. These connectors are located in the
bottom end panel of the programmer as shown in the illustration below....
The pin-out of these IDC connectors are shown below....
1
A full explanation of each pin-out is available in the relevant chapters referred to in the table below...
#
Target ISP
Connector type
connector
1
Target ISP
16-way 0.1" IDC female
Connector
(bump polarised)
#1
2
Target ISP
10-way 0.1" IDC female
Connector
(bump polarised)
#2
ISPJUNO - Portable ISP Programmer - User Guide V0.84 – 17/04/20
2
Comment
Further information
Same as
See section 3.3
ISPnano 16-way
connector
Same as
See section 3.4
standard
Equinox 10-way
connector with a
few exceptions
33
Advertisement
Table of Contents
