Table of Contents
Advertisement
2.5 Programmer Status LEDs
The current status of the programmer is displayed on the programmer Status LED's as detailed in the
table below.
Fig. 2.6.5 Programmer Status LED's – state descriptions
Status LED
State
Display
WAITING
BUSY
FAIL
PASS
Status LED key:
Please note:
•
There are also two special modes called 'Waiting Target Connection' or 'Waiting Target
Disconnection' where the yellow 'BUSY' LED will FLASH.
•
These modes are enabled when 'Target Connection Sense' is enabled in the Programming
Project.
ISPJUNO - Portable ISP Programmer - User Guide V0.84 – 17/04/20
State Description
•
Programmer is now waiting to start an 'Autoprogram'
operation.
•
Programmer is 'BUSY' performing a programming
operation.
•
If the programmer is controlled from EDS, the BUSY LED
will remain on after a programming operation until a
'RESET programmer' command is executed.
•
Programming operation has FAILED.
•
See programmer LCD for diagnostics
•
Programmer will automatically switch off target power if it
is controlling power.
•
Programming operation was successful.
17
Advertisement
Table of Contents
