Market Forge Industries UniVerse Plus Series Installation & Operation Manual page 9

INSTALLATION & OPERATION MANUAL, GAS TILTING SKILLETS,
MODELS: 30P-STGL, 30P-STGL-LX, 40P-STGL, 40P-STGL-LX,
30P-STGM, 30P-STGM-LX, 40P-STGM, 40P-STGM-LX
START-UP PROCEDURE
1. Open manual gas shutoff valve.
2. Ensure that the braising pan is in the DOWN position.
3. Turn THERMOSTAT dial to desired setting. The red TEMPERATURE LIGHT will come on.
This will turn on the electronic ignition which will light the burners.
4. If the burners do not come on after 30 seconds, turn THERMOSTAT OFF and then ON
again for restart.
5. When braising pan has reached set temperature, the red TEMPERATURE LIGHT will go off
and the burners will shut off. The burners will cycle on and off thereafter to maintain set
temperature. The red TEMPERATURE LIGHT will be on when the burners are on and off
when burners are off.
6. If gas supply is interrupted during operation, turn THERMOSTAT dial to OFF position and
turn gas supply OFF. Wait five minutes, then repeat Steps 1 through 4 to restart.
7. Turn THERMOSTAT to OFF when braising pan is not in use.
SHUTDOWN INSTRUCTIONS
Turn the thermostat counterclockwise to off position.
PROLONGED SHUTDOWN
Prolonged Shutdown
1. Turn the thermostat counterclockwise to off position.
2. Turn gas valve located at right-rear to off position.
Part No. 10158R3 9 2019-05-24