Market Forge Industries UniVerse Plus Series Installation & Operation Manual page 20

Gas tilting skillet

INSTALLATION & OPERATION MANUAL, GAS TILTING SKILLETS,

MODELS: 30P-STGL, 30P-STGL-LX, 40P-STGL, 40P-STGL-LX,

30P-STGM, 30P-STGM-LX, 40P-STGM, 40P-STGM-LX

SECTION 5, TROUBLESHOOTING & MAINTENANCE (Continued)

CLEANING

The skillet should be cleaned daily.

Wash the skillet with a mild detergent and hot water. If food is stuck to the surface of the

skillet pan, soak it and use a little heat to loosen the food. Then, wash with clear water and

dry.

Be sure to wash under the skillet cover and rinse with clean water.

Check the skillet pouring lip corners to be sure they are clean. Also, wash around the

exterior of the skillet. Rinse with clean water and air dry.

ADJUSTMENT OF MOTOR TILT-STOP SWITCHES

Tilt skillet pan all the way in the down or horizontal position until the stops in the back

engage.

Tilt control box cover up by first removing two pan head screws in the lower front of the

console. Use the prop arm located inside, in the rear vertical column, to keep the console

cover tilted open. Caution, circuit is live! Electrical power has not been turned off.

Remove control console lower side cover to expose motor, tilt cam and switches.

Using a 9/64 hex key, loosen the two set screws on the tilt cam located on the outside hub

of the tilt gear.

Turn the cam so that one of the arms just engages the upper-right tilt switch as the arm is

turned clockwise. Hold the cam/arm in that location and tighten the set screws.

Using the tilt UP/DOWN switch on the control panel, test the full travel up and down on the

pan. The motor should stop just before the pan back stops engage in the horizontal

position. It should stop at about 80 in the up or vertical position.

Repeat steps 4 to 6 until motor tilt stops as described in step 6.

Replace the control console lower side cover in its original position. Close and fasten the

control console by tightening the two screws at the lower front of the box.

Part No. 10158R3

2019-05-24

Table of Contents