Market Forge Industries UniVerse Plus Series Installation & Operation Manual page 8

INSTALLATION & OPERATION MANUAL, GAS TILTING SKILLETS,
MODELS: 30P-STGL, 30P-STGL-LX, 40P-STGL, 40P-STGL-LX,
30P-STGM, 30P-STGM-LX, 40P-STGM, 40P-STGM-LX
GENERAL INSTALLATION (Continued)
d. Propane gas units are equipped with a pressure regulator factory-adjusted to give 10"
(254 mm) water column manifold pressure. The supply pressure must be at least 11"
(279 mm) water column pressure.
e. Maximum supply pressure must not exceed ½ psig (3.45 k/PA) for both natural and
propane gas.
f. Perform a gas leak test of all newly-made joints, as well as those leading to the main
gas control valve and pilot burner, using a soap solution. Do not use flame.
8. Electrical service connection:
Connect skillet controls to 110/120 volt AC, 60 Hz, single-phase branch circuit rated 15
amps capacity. Wiring will conform to the requirements of national and local electrical
codes (220 volts, 50 Hz, single-phase for export units). Only a licensed electrician
should make electrical connection.
INSTALLATION WITH CASTERS
1. Installation shall be made with a connector that complies with the Standard for Connectors
for Moveable Gas Appliances, ANSI Z21.69, CAN/CGA-6.16, and a quick-disconnect device
that complies with the Standard for Quick-Disconnect Devices for Use with Gas Fuel, ANSI
Z21.41 or the Standard for Quick-Disconnect Devices for Use with Gas Fuel, CAN-6.9.
2. Adequate means must be provided to limit the movement of the appliance without
depending on the connector and the quick-disconnect device or its associated piping to limit
the appliance movement.
3. The location(s) where the restraining means may be attached to the appliance shall be to
the optional bracket located on the lower end of the right hand pan cover post assembly in
the rear of the unit.
BEFORE FIRST USE
Using a non-corrosive, grease-dissolving commercial cleaner, clean the protective metal oils
from all surface parts and the interior of the tilting braising pan. Follow the cleaner
manufacturer's directions. Rinse thoroughly and drain the pan. Wipe dry with a soft clean
cloth.
Part No. 10158R3 8 2019-05-24