Market Forge Industries UniVerse Plus Series Installation & Operation Manual page 11

INSTALLATION & OPERATION MANUAL, GAS TILTING SKILLETS,
MODELS: 30P-STGL, 30P-STGL-LX, 40P-STGL, 40P-STGL-LX,
30P-STGM, 30P-STGM-LX, 40P-STGM, 40P-STGM-LX
OPERATION OF UniVerse TILTING SKILLET WITH ELECTRONIC IGNITION (Continued)
Note: For best results, allow unit to cycle ON/OFF once.
6. Cover should be up for most types of cooking, except simmering or boiling. The cover has
a lip at the rear that will direct condensate into the skillet rather than onto the cabinet base.
7. When food is cooked, it should be immediately removed from skillet to prevent overcooking.
8. To lower skillet, merely turn tilt skillet hand crank counterclockwise. To raise skillet, turn
hand crank clockwise.
Note: "LX" models are raised and lowered using switch on front of control box.
9. For cleaning instructions, see Section 6–Troubleshooting and Maintenance.
• Disconnect the power supply to skillet before cleaning or servicing. (Note: "LX" models
should have the skillet raised to washing position before disconnecting power supply.)
• Keep this appliance area free and clear of combustibles.
• Do not obstruct the flow of combustion and ventilation air.
• If skillet pan is difficult to raise, the lift gears may need to be lubricated. The gears are
located on the right side under the control box. Apply a liberal amount of grease along the
helical thread of the worm where it engages the worm gear. Use multi-purpose, NLGI #2
lithium-based, water-resistant grease.
• Keep this manual for future reference.
• Consult the factory, the factory representative, or a local service company to perform
maintenance and repairs.
• In the event of a power failure, do not operate appliance.
• Periodically examine the flue outlet located behind the skillet cover for any obstructions.
• Appliances with casters are always to be restrained from movement. If removal of the
restraint is necessary, always reconnect the restraint when the appliance is returned to its
originally installed position.
Part No. 10158R3
CAUTION: BE SURE TO READ
11 2019-05-24