Table of Contents
Advertisement
SATEL
3.1
Wiring diagram
The KNX-BIN24 module has two independent circuits. Each circuit includes four inputs: A, B,
C, D – circuit 1, and E, F, G, H – circuit 2. DC or AC voltage can be applied to each module
input, allowable input voltage ranging from 0 to 30 V.
Input voltage from 0 to 4 V is interpreted as "0" and voltage from 9 to 30 V – as "1". To
avoid malfunctioning of the module, voltage ranging from 4 to 9 V must not be applied
to any input.
Each module input can be connected to a different current source, but one type of voltage,
either DC or AC, must be applied to inputs belonging to one circuit.
Fig. 3 shows some examples of module connection:
I – voltage from one source, AC or DC, is applied to all inputs of the module,
II – voltage from two different sources is applied to inputs of circuits 1 and 2 (DC voltage is
applied to inputs of one circuit, and AC voltage to inputs of the other circuit),
III – voltage from different sources is applied to inputs within one circuit (DC voltage is
applied to inputs of one circuit, and AC voltage to inputs of the other circuit).
4. Configuring the module
Working parameters of the module are defined in the ETS program (version 5.5 or higher).
The tabs for defining individual parameters are built dynamically. Depending on the selected
options, further parameters may be displayed in the tabs or further tabs may be displayed
when defining parameters. Moving the cursor over the selected parameter will display
a tooltip with default value or value range for that parameter.
KNX-BIN24
5
Advertisement
Table of Contents
