Assembly Instructions - Landoll 7831 Operator's Manual

It is very important that your new 7831 High Speed
Landoll (HSL) be properly assembled, adjusted and
lubricated before use. Illustrations in this section show
proper assembly procedures. Remove paint from grease
fittings. Replace any grease fittings that are damaged or
missing. Be sure to return screws, clips, etc., to their
original locations.
To insure alignment of assemblies, leave the nuts loose
until completion of final assembly. Use lock washers or
flat washers as specified. Spread all cotter pins.
After completion of final assembly, tighten all nuts
evenly to prevent misalignment, distortion or binding.
Tighten all screws and nuts to the recommended torques
shown in Table 2-1.

Disc blades are extremely sharp. Exercise
extreme care when working on or near disc
blades. Do not allow discs to roll over or fall onto
any bodily part. Do not allow wrenches to slip
when working near disc blades. Never push
wrenches toward disc blades. Do not climb over
machine above disc blades. Failure to stay clear
of disc blade edges can cause serious personal
injury or death.
DANGER

Assembly Instructions


Do not attempt to lift heavy parts (such as the
frame, disc gangs, rock shaft, and pull hitch)
manually. Use a hoist or a fork lift to move these
parts into position.

To prevent accidental lowering:
1. All hydraulically elevated equipment must be
locked out using the cylinder lockouts.
2. Lower equipment to the ground while
servicing or when it is idle.
Failure to take measures to prevent accidental
lowering may result in serious personal injury or
death.

Be sure to bleed the hydraulic system of all air in
lines after installation. Failure to bleed the system
of all air can result in improper machine
operation.

Incorrect adjustment of disc adjust rods will
cause permanent equipment damage.
Chapter 3
WARNING
DANGER
CAUTION
CAUTION
3-1