Adjusting The Blade Leveler - Landoll 7831 Operator's Manual

OPERATION AND MAINTENANCE

Adjusting the Blade Leveler

Without the blade leveler, it is inherent that the left rear
corner blade of the machine would leave a small divot
because there is not any dirt flow to fill the void left by the
left rear blade. The "Blade Leveler" re-directs soil from a
single twenty-two inch cover disc blade. It redirects into
the area mentioned above. The Blade Leveler is
adjustable both in height, angle, and laterally. The cover
disc can be adjusted laterally.
The performance of the blade leveler is a function of both
speed and field conditions (loose dirt present.)
4-8
1. It is best to initially adjust the blade to ride at ground
2. If the ground speed will be ten miles per hour or
Figure 4-5: Adjusting The Blade Leveler
level, with the bottom edge parallel to the ground. If it
is set to high the loose dirt will escape underneath of
the blade and not be delivered to where it is needed.
more, gap the blade leveler laterally a bit further left
of the left end cap of the left rear gang. It is most
effective when positioned approximately 1" to 1-1/2"
to the left of the left rear gangbar's left side end cap
(See Figure 4-5.)
F-801-1115 Edition