TVS APACHE RTR 200 4V Training Handbook page 9

Digital clock setting
Press and hold the 'Mode' button till 'MPH' icon blinks in display.
l
Release and press the 'Mode' button once again so that the 'Clock' icon blinks.
l
On pressing the 'Set' button, 'CLOCK MODE' scrolls in running display and the hour digit of the clock blinks.
l
Now, press the 'Mode' button to increase the hours while hour digits are blinking.
l
On pressing the 'Set' button again the hours of the clock is set and the minute digit blinks.
l
Now, press the 'Mode' button to increase the minutes while minute digits are blinking.
l
Else, on pressing the 'Set' button again the minutes of the clock is set and the hour format 'AM' or 'PM'
l
blinks.
Press the 'Mode' button to change the hour format 'AM' or 'PM'.
l
Press the 'Set' button once again to set hour format and to come out from clock setting.
l
Setting the Shift RPM
Press and hold the 'Mode' button till 'MPH' icon blinks in display.
l
Release and press the 'Mode' button twice so that the 'RPM' icon blinks.
l
Press the 'Set' button to reach shift RPM setting mode the 'SHIFT RPM' icon scrolls in running display for
l
one cycle. Previous RPM setting value is displayed in the bar display and LED will glow.
Now, press the 'Mode' button to increase the RPM (multiples of 1000) in cyclic fashion. Once the user
l
starts updating, the LED stops glowing.
Pressing the 'Set' button exits the setting. Once the shift RPM is set, the LED again glows and mode is exit.
l
-8-