TVS APACHE RTR 200 4V Training Handbook page 8

D. Lap timer
Lap timer indicates the time taken to complete the lap.
In 'TRIP 2' meter mode, Press mode button once to enter lap timer mode. After speedometer enters lap timer
mode, press SET button for more than 1 sec. After set button input, lap timer indicating digit blinks. Lap timer
will start counting when the vehicle speed is more than 3 km/h and stops blinking once it starts counting . Lap
timer will stop counting and starts blinking once the vehicle speed reduces below 3 km/h. Blinking will stop
once the vehicle comes to neutral. New lap can be started once the data is cleared by changing the mode or by
turning 'OFF' and 'ON' the ignition.
E. Alpha numeric display
The self diagnostic alpha numeric display indicates the information about current mode and error messages
when the ignition key is turned ON.
F. High speed indicator
High speed indicator records the maximum speed (top speed) achieved by the rider so far either in km/h or
mph as per preferred setting. You can reset and record the new speed if required. Set the meter in
'HIGHSPEED' mode to know the maximum speed achieved by any user so far.
Whenever the vehicle speed crosses the previous achieved high speed then speedometer will scroll
'ACHIEVED HIGH SPEED' in display and flash the high speed data at the rate of 2 Hz till the scrolling completes
when speed comes less than 3 km/h. This will happen in all modes except shortest time mode. Maximum
speed recorded so far will be displayed whenever the meter is set in 'HIGH SPEED' mode. This display will go
off automatically once the vehicle starts moving (>1 km/h) and it will continue the normal operation. Max
speed recorded will be stored until its reset. To reset the high speed recorded, keep the display in 'HIGH
SPEED' mode and press the 'Set' button for a few seconds. If the high speed is reset, the speed value will be
shown as '0'.
G. Shortest time indicator
Shortest time indicator records the minimum time taken so far to reach 60 km/h or 40 mph speed (according to
the preferred setting). You can reset and record new time if required. Set the meter in 'SHORTEST TIME'
mode to know the time taken by a rider to reach the specific speed from starting. Minimum time taken
recorded so far to reach 60 km/h or 40 mph speed will be displayed when the ignition is turned 'ON' and the
meter is set in 'SHORTEST TIME' mode. Once the speed reaches 60 km/h or 40 mph, then the time will stop
at the exact point.
The best time achieved by any user and the last time taken to reach 60 km/h or 40 mph speed will be displayed
in 'SHORTEST TIME' mode as shown below. You can only reset the last time taken and record new time. The
'best record' time will be automatically replaced by next best time and the new best time recorded will be
flashed and 'BEST SHORTEST TIME' scrolls in running display when the vehicle comes less than 3 km/h. To
reset the 'LAST RECORD' of the shortest time, press and hold the 'Set' button for few a seconds. Please
remember only current record will be reset and best time display will remain same.
Mode and set buttons will not work when the vehicle speed exceeds above 10 km/h or 6 mph in the
respective modes.
BEST RECORD
LAST RECORD
-7-