TVS APACHE RTR 200 4V Training Handbook page 28

3. Hold the wheel by hand and rotate it ¼ turn
downwards (angle 'L' indicated in the figure) and
leave. When the wheel is left, if the wheel does not
rotate further ('up' or 'down'), it may be concluded
that the wheel is balanced. If the wheel rotates 'up' or
'down', then the wheel needs to be balanced further.
4. If the wheel rotates and the weight goes up, replace
the weight with next heavier size by referring Table 1.
Further, if the wheel rotates and the weight goes
down, replace the weight with the next lighter size
from the Table 1.
5. Repeat the steps 3 & 4 till the wheel remains at rest
after being rotated ¼ turn.
6. For final confirmation, rotate the wheel further ¼ turn
(by hand) and yet again another ¼ turn. In both the
cases, if the wheel comes to a rest after ¼ turn
rotation, it may be concluded that the wheel is
balanced.
After final confirmation, the balancing weight must be
fixed permanently at the locations decided earlier.
Follow the procedure given below for fixing the weight
permanently.
1. Remove the temporarily fixed balancing weights and
clean the wheel rim surface with IP 80% solution
(cleaning agent) at the designated location where the
balancing weight needs to be fixed again.
2. Remove (peel off ) the protective cover on the back
side of the balancing weight as shown.
3. Stick the balancing weight at the cleaned location on
the wheel rim with a minimum pressure of 1 kg/cm
and hold for 3 Sec (min).
SL.No. Part No.
1 N732 016 0
2 N732 017 0
3 N732 018 0
4 N732 019 0
5 N732 020 0
6 N732 021 0
2
-27-
A
Angle 'L'
Q
Table 1
Weight
5 g
10 g
15 g
20 g
25 g
30 g
B