Table of Contents
Advertisement
If no MAS-A100 is found after pressing the [Scan] button, check the network
connection and firewall settings (see "Firewall" in the "MASM-1 preparation"
section).
2.
From the list of discovered MAS-A100 units, place a check mark beside the
MAS-A100 units to register in MASM-1.
Change the IP address, subnet mask, and default gateway of the MAS-A100 units
so that the MAS-A100 units are on the same subnet as the PC and the IP address
can be accessed from the PC.
Do not configure an IP address already configured on another device.
If already on the same subnet as the PC, there is no need to change settings.
3.
Press the [Set] button.
The IP address, subnet mask, and default gateway of the selected MAS-A100
units are applied. Proceed to the next step.
27
Advertisement
Table of Contents
