Table of Contents
Advertisement
System settings
1.
Select [System] from the pull-down menu.
2.
Press the [Flash] icon to start the LED lamp of the MAS-A100 flashing to confirm
its location, if necessary.
3.
Check the [Default Dante ID].
4.
Check the MAC address.
This MAC address is used for MAS-A100 setup and operation functions. It is not
the MAC address as a Dante device. The MAC address as a Dante device can be
checked using Dante Controller.
5.
Check the serial numbers.
6.
Set whether to enable control from an external device.
For details, see "External Control".
7.
Press the [Restart] button, as required.
The MAS-A100 restarts. While restarting, the MAS-A100 is offline and the status
lamp is gray.
8.
Set a time for scheduled restart.
If the time is set in the range 0:00 to 23:00, the MAS-A100 automatically restarts
at the specified time every day, based on the internal clock of the MAS-A100.
9.
Press the [Set] button.
The changes for external control and scheduled restart are saved.
43
Advertisement
Table of Contents
