After Replacing A Drive - Bosch DSA E‑Series Installation Manual

DSA E-Series (E2800 60-bay)
2.
3.
4.
5.
8.1.4

After replacing a drive

After replacing a drive, you must confirm that the new drive is working correctly.
To confirm that the new drive is working correctly:
1.
The Activity LED is on or blinking, and the
Attention LED is off.
The Activity LED is off.
The drive drawer's Attention LED is on.
Bosch Security Systems B.V.
Align the two raised buttons on each side of the drive carrier with the matching gap in the
drive channel on the drive drawer.
1 = Raised button on the right side of the drive carrier
Lower the drive straight down, and then rotate the cam handle down until the drive snaps
into place under the orange release latch.
Carefully push the drive drawer back into the unit.
Note: Possible loss of data access: Never slam the drawer shut. Push the drawer in slowly
to avoid jarring the drawer and causing damage to the unit.
Close the drive drawer by pushing both levers towards the center.
The green Activity LED for the replaced drive on the front of the drive drawer comes on
when the drive is inserted correctly.
Note: Depending on your configuration, the controller might automatically reconstruct
data to the new drive. If the unit uses hot spare drives, the controller might need to
perform a complete reconstruction on the hot spare before it can copy the data to the
replaced drive. This reconstruction process increases the time that is required to
complete this procedure.
Check the Activity LED and the Attention LED on the drive you replaced.
LED status
1
The new drive is working correctly.
The drive might not be installed correctly.
Remove the drive, wait 30 seconds, and then
reinstall it.
The new drive might be defective. Replace it
with another new drive.
Installation manual
Maintenance | en
Description
2020-05 | V2 | DOC
39